True Bypass - DPDT switch in a TS-10

[navvid]

I have modded my TS-10 to TS-808 spec, and would like to add a "true bypass" switch. I am aware that the case won't fit the switch, but I can work around that, and if worse comes to worse, I'll recase it. What I am not sure of is how to wire the switch. I don't want to add an led indicator, so I believe all I need is a DPDT switch. I have looked at various tutorials, but I am still a little unclear about how it works. There are two wires (green, and orange) going to the stock switch on my TS-10. What are they in terms of the switch wiring?

Any help or input appreciated.

 

[duhvoodooman]

This is how I would recommend wiring a true-bypass DPDT:

If you wanted to also add an LED indicator and use a 3PDT switch, wire like so:

These excellent diagrams courtesy of my fellow moderator Stephen over at the BYOC forums....

 

[navvid]

Thanks Voodoo, you da man. But one more question, of the green and orange wires that go to the original switch, which is the pcb in, and which is out?

 

[duhvoodooman]

But one more question, of the green and orange wires that go to the original switch, which is the pcb in, and which is out?

Don't know--you'll have to look at the PCB component labeling and the traces. The input should quickly connect to the low number components--C1, R1, etc. The output should connect to the high numbers; on the TS-10 schematic I have, the last components before the output are resistors R21 and R22. You probably replaced these two as part of the TS808 conversion....