Experienced Modder Needed - HELP

[just strum]

on the attached it shows the red and white wires taped or secured together - do you know if they should be stripped at the end or left with casing on???

http://www.seymourduncan.com/pdfs/support/schematics/2h_2v_2t_3w.pdf

 

[tunghaichuan]

Strip the wires, solder them together and insulate them. They need to be connected to complete the circuit.

tung

on the attached it shows the red and white wires taped or secured together - do you know if they should be stripped at the end or left with casing on???

http://www.seymourduncan.com/pdfs/support/schematics/2h_2v_2t_3w.pdf

 

[mrmudcat]

Yea what he said. They can also be shrinked wrap after soldering together or just electrical tape:beer:

 

[just strum]

whew, that's what I did on the bridge pup and then started second guessing myself. Thanks for the quick response.

 

[tunghaichuan]

Yea what he said. They can also be shrinked wrap after soldering together or just electrical tape:beer:

Electrical tape works in a pinch, but I personally hate the stuff. It always gets nasty sticky residue on anything it is wrapped around. Heat shrink is much better for guitar electronics. Just sayin' Rat Shack used to sell a package of heat shrink. Not great, but better than electrical tape.

tung

 

[mrmudcat]

I agree I shrink wrap as ive been doing on puters or guitars.:rotflmao: